ULINKPro with JTAG

I have a ULINK Pro connected to an STM32F4. When I select the JTAG port instead of SW port it reports 2 devices. 0x4BA00477 ARM CoreSight JTAG-DP 0x06413041 Unknown JTAG device Why would I get...
ULINKPro with JTAG

I have a ULINK Pro connected to an STM32F4. When I select the JTAG port instead of SW port it reports 2 devices. 0x4BA00477 ARM CoreSight JTAG-DP 0x06413041 Unknown JTAG device Why would I get...
ULinkPro with TI RM48L952

ARM MDK 4.73, TI RM48L952, 20 pin JTAG connection. When I select the TI RM48L952 processor in the MDK the only JTAG device that is available to select is the Segger JLINK even though I have a ULinkPro...
Boundary Scan with ULINKpro

I am looking information about using ULINKpro to do Boundary Scan with JTAG (IEEE Std. 1149.1). It seems that ULINKpro should support this, but I can't find information or examples of anyone doing...
Debugging issue with ULINKPro

Hello, I am using a ULINKPro on a MCB1700 (LPC1768) dev board. I am having an issue where when I setup and run in debug mode, the code will break where I set a break point but when I press F10 to just...