ULINK2 device couldnt program the target

Hi, I installed the KEIL software in a older model laptop. Now whenever i try to program my target board i get the message "Couldnt stop ARM device. Check the JTAG cable". It was running with...
ULINK2 device couldnt program the target

Hi, I installed the KEIL software in a older model laptop. Now whenever i try to program my target board i get the message "Couldnt stop ARM device. Check the JTAG cable". It was running with...
Keil cannot find DAPLink with new version firmware

Hello, I'm trying to build DAPLink for my STM32F103CB board, however Keil cannot find DAPLink with new version firmware. This is my discovery: If I build DAPLink with the newest release (v0257)...
Where can I find the linker script used to set up Morello in bare metal mode at EL3?

The _start code in crt0.S located in newlib is used to initialise Morello for bare metal mode at EL3, but where can I find the linker script for this set up? There are a number of ld files in newlib but...
Where can I find the linker script used to set up Morello in bare metal mode at EL3?

The _start code in crt0.S located in newlib is used to initialise Morello for bare metal mode at EL3, but where can I find the linker script for this set up? There are a number of ld files in newlib but...