Simulation of Oregano Systems 8051 IP core too slow?

Dear all, altough i selected the correct target device and clock speed, i see that the Oregano IP core takes the same amount of time for one operation like an original 8051. In fact, the Oregano...
Simulation of Oregano Systems 8051 IP core too slow?

Dear all, altough i selected the correct target device and clock speed, i see that the Oregano IP core takes the same amount of time for one operation like an original 8051. In fact, the Oregano...
CLOCK TOO SLOW AND MUST BE FASTER

I NEED THE PORCESSOR TO RUN AT 82MHZ BUT THE XTAL IS 13>7242MHZ HOW DO I PROGRAM C TO GET THE CODE FASTER? I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT...
CLOCK TOO SLOW AND MUST BE FASTER

I NEED THE PORCESSOR TO RUN AT 82MHZ BUT THE XTAL IS 13>7242MHZ HOW DO I PROGRAM C TO GET THE CODE FASTER? I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT...
Port pins too slow

Hi.. I have a problem with the xc167ci. Its I/O-Pins toggle too slowly. If I have e.g. pin 4^0 toggeling, it only works with 2,85 MHz instead of 40 MHz (system clock). I use the following sourcecode...