ACCESS DALLAS DS80C400 CAN SRAM

Hello I'm trying to initialize the CAN controller on the DS80C400 but I cant set the bit SWINT (C0C.0) to 0 (so the CAN controller never starts up). I wrote some valid values to C0BT1 (TSEG1 and TSEG2...
ACCESS DALLAS DS80C400 CAN SRAM

Hello I'm trying to initialize the CAN controller on the DS80C400 but I cant set the bit SWINT (C0C.0) to 0 (so the CAN controller never starts up). I wrote some valid values to C0BT1 (TSEG1 and TSEG2...
use of ISD51 with Dallas DS80C400

Hello, I am developing with a Dallas DS80C400 (not a TINI board) & think I need to use the ISD51 debugger. There isn't an example for this specific chip in the Keil install - any tips on getting it...
Serial interrupt function in Dallas DS80C400

Dear all, I have attempted to send a character through serial port 2 in the Dallas DS80C400. However, it seems that the interrupt service routine of serial port 2 does not occur. Could anyone check...
Serial interrupt function in Dallas DS80C400

Dear all, I have attempted to send a character through serial port 2 in the Dallas DS80C400. However, it seems that the interrupt service routine of serial port 2 does not occur. Could anyone check...