PROBLEM TO INITIATE GPIF WRITE

Hi, The code to initiate te GPIF write is given below. I use LED blinking for debugging the code stage. At initial condition GPIFDONE bit is high (meaning GPIF engine is idle.) when I initiate a write...
PROBLEM TO INITIATE GPIF WRITE

Hi, The code to initiate te GPIF write is given below. I use LED blinking for debugging the code stage. At initial condition GPIFDONE bit is high (meaning GPIF engine is idle.) when I initiate a write...
GPIF Interrupts

Hi there, I am using the EZ-USB NX22LP-Flex development board, and I need to set up a NAND read routine. According to the Tech Reference Manual, it requires setting up INT4 as an internal source...
GPIF Interrupts

Hi there, I am using the EZ-USB NX22LP-Flex development board, and I need to set up a NAND read routine. According to the Tech Reference Manual, it requires setting up INT4 as an internal source...
How can I change the pipeID in cy7c68013?

I use the cy7c68013 with slave fifo and auto in-out mode. And now 4 bulk pipe is used with piptID 2,4,6,8 but I want to chage last pipe 8 to 10, so edit and compile and download iic file of dscr.a51...