• JTAG error: could not stop arm device
    Hello, I'm very new to keil products. I'm working with the MDK (latest version) and the ulink2 interface to upload some code to my target (AT91RM9200 controller) - but I get always the error "could...
  • JTAG error: could not stop arm device
    Hello, I'm very new to keil products. I'm working with the MDK (latest version) and the ulink2 interface to upload some code to my target (AT91RM9200 controller) - but I get always the error "could...
  • Could not stop ARM devices
    "Could not stop ARM devices,please check JTAG cables" will frequently occues, if you use keil Vision IDE, the follows are some common reasons that cause the error. 1. JTAG cables issue 2. JTAG speed...
  • Could not stop ARM device!
    Hello. I am trying to load my code into a LPC2129 with ULINK2 and appears an error message saying: "Could not stop ARM device! Please check the JTAG cable". I tried to change the JTAG clock to 100 kHz...
  • "could not stop ARM device"
    uVision 3... I try to stop the debugger to see why my application is crashing. But then I get "Could not stop ARM device! Please check the JTAG cable." I then have to cycle power to be able to run my...