Reset UlinkPro Tool via DOS Command Line

Is there a method via a Dos command batch file, to perform a reset of the actual ULINKPRO Module Tool? Having an issue where I have to unplug the Ulink Tool upon a PC reboot.
Reset UlinkPro Tool via DOS Command Line

Is there a method via a Dos command batch file, to perform a reset of the actual ULINKPRO Module Tool? Having an issue where I have to unplug the Ulink Tool upon a PC reboot.
Command line .hex flash programming

I have to use command line flash programming for a project . So I created a fake project similar thand the original one. The problem is that I'm using a .ini for flash downloading to program a modfied...
Command line .hex flash programming

I have to use command line flash programming for a project . So I created a fake project similar thand the original one. The problem is that I'm using a .ini for flash downloading to program a modfied...
Error on Command line function of Flash Magic in uVision2 IDE

Hello, I have just used Phillips MCU P89C51RD2BN. I tested the ISP on independent Flash Magic successfully. I also want to use the command line function of flash magic on uVision2 IDE. But when I add...