USB HOST and Client at the same time

Is it possible to set up USB host one one USB port and Client on the other ? Regards, MP.
USB HOST and Client at the same time

Is it possible to set up USB host one one USB port and Client on the other ? Regards, MP.
STM32L4xxx and RTOSv1/. Sending two signals from one ISR at the same time, to the same thread, results in abnormal behavior.

Using uVision v5.27.1.0 (RTOS 1) with STM32L4xxx. In an ISR two different signals are sent to the same thread like below: . . osSignalSet(myTask, SIGNAL_1); osSignalSet(myTask, SIGNAL_2); ....
STM32L4xxx and RTOSv1/. Sending two signals from one ISR at the same time, to the same thread, results in abnormal behavior.

Using uVision v5.27.1.0 (RTOS 1) with STM32L4xxx. In an ISR two different signals are sent to the same thread like below: . . osSignalSet(myTask, SIGNAL_1); osSignalSet(myTask, SIGNAL_2); ....
USB Host and Device at the same time (LPC2478)

Hi I could find a lot of sample codes which are just based on USB device or just USB Host, But I need to connect an USB Flash card to MCU through USB Host and at the same time I need to connect MCU...