Does uVision5 Simulator supports CAN peripheral Simulation?

Hi Everyone I am trying to run a simple CAN application using the simulator of Keil ARM-MDK V5.22 (uVision 5). But I have doubts about whether Keil uVision 5 supports simulation of CAN peripheral...
Does uVision5 Simulator supports CAN peripheral Simulation?

Hi Everyone I am trying to run a simple CAN application using the simulator of Keil ARM-MDK V5.22 (uVision 5). But I have doubts about whether Keil uVision 5 supports simulation of CAN peripheral...
Peripheral simulation

I have read this article http://www.keil.com/support/docs/2443.htm It says: If you set the PORT1 VTREG to a value of 0xAA (by typing PORT1=0xAA in the Command Window), your target program will read...
Peripheral simulation

I have read this article http://www.keil.com/support/docs/2443.htm It says: If you set the PORT1 VTREG to a value of 0xAA (by typing PORT1=0xAA in the Command Window), your target program will read...
8051 Peripheral Simulation

Hello, I use Keil uvision evaluation tool to work with both ARM and 8051 processors. My problem is that while working with 8051, I am not able to simulate the on chipe peripherals. In fact, while...