Simulation - Pins and Port

Hello all, I'm using the simulator for years but now I have a serious problem even when I'm going back to the "Hello World!" example: For example Port 2 (P2) is configurated as input (DP2 = 0)....
simulating the serial port

i make a small program which includes initializing the baud rate, serial port1 control and what mode it would operate. I also include this: mov a, #33h mov scon1, a mov a, #00h mov a, scon1...
Simulation - Pins and Port

Hello all, I'm using the simulator for years but now I have a serious problem even when I'm going back to the "Hello World!" example: For example Port 2 (P2) is configurated as input (DP2 = 0)....
simulating the serial port

i make a small program which includes initializing the baud rate, serial port1 control and what mode it would operate. I also include this: mov a, #33h mov scon1, a mov a, #00h mov a, scon1...
I/O Port Simulation mismatch?

I have two simple code examples: ; Example 1 ORG 0 MOV A,#0xff MOV P0,A TOP: MOV P1,P0 SJMP TOP END ---------------------- ; Example 2 ORG 0 TOP: MOV A,#0xff MOV P0,A MOV P1,P0...