Tricopter on a LPC1758

Code name Cerberus Abstract The goal of this project is to produce a stable hovering tricopter. This craft will hover using three motors with three propellers, one of which is mounted on a swivelling...
How to configure Cortex M3 endianness?

I found two statements in cortex m3 guide(red book) 1. Cortex m3 supports both Little as well as big endianness. 2. After reset endianness cannot be changed dynamically. So indirectly it is telling...
Smart Planter Project on LPC1758

I thought I'd share a project I made last semester as part of my real-time embedded systems course at San Jose State University. It was developed on the SJ One Board which utilizes the NXP LPC1758 (ARM...
Autonomous RC Cars based on NXP LPC1758

We recently had an event here at the San Jose office where we hosted a dozen Graduate students from San Jose State University for them to present their Autonomous RC cars. This was part of a one semester...
Arm cortex M3(LPC1769) MPU settings

Hello everyone, I am trying to set up the MPU in my LPC1769 Xpresso board. The memory map of LPC1769 is as given below: 512kB FLASH @ 0x0000 0000 – 0x0007 FFFF 32kB on-chip SRAM @ 0x1000 0000 – 0x1000...