• Instruction Set Manual Question
    I was unsure as to what the meaning of "Bytes" was in the description of a given instruction. For example: For the MOV opcode, two of the given mnemonics are: MOV @Rn, #immediate C AC F0 RS1...
  • Integrating a third-party jtag debugger to keil uvision
    Hello. I would like to integrate third-party debugger "emulator that supports JTAG debugging for ARM7 and ARM9 devices" to keil uvision , so I could flash LPC2214 using that debugger . Our university...
  • Manual
    Please send me the Software development manual for the N79E352 controller.
  • FX2 Slave FIFO Manual Mode sample code
    Hi , Have anybody worked on Cypress FX2 chip. I am writing the firmware for slave FIFO to access the external logic data. Since my FW has to filter out some data so I have to use AUTOIN =0 mode. ...
  • Are you expected to manually set registers in Keil µVision?
    In the university we had to programm all registers manually. You were only given the header file for the device with all of the registers. From what I have understood Keil acts like an interface to set...