• flash magic error
    i am trying to perform stepper motor interfacing with 8051 micro-controller.micro controller board-DYNA-51EB..Hex file is created in keil software.but using flash magic it is not able to transfer hex...
  • USING FLASH MAGIC
    Hello, i have build a isp programmer for micro lpc i use the rs232 signal and flash magic for programming i would program the micro directly by keil it is possible this?
  • COMMAND LINE
    WHAT IS COMMAND LINE IN KEIL? HOW TO PASS PARAMETER VIA IT? FOR COMPILING PROGRAM BY --C99 WHICH PARAMETER HAS TO BE SET
  • ERRORLEVEL from command-line invocation of uVision2
    I am integrating our builds into the Ant and CruiseControl architecture, but have run into a problem: when invoking uVision2 from the command line, e.g.: uv2 -b washer.uv2 uVision2 never sets ERRORLEVEL...
  • Convert uVision2 project to a command line compile
    Is there any way to convert a uVision2 project into a command line compile? Thanks for any info!