• Error: Cannot access target
    When debugging STM32L152VD using ST-LINK V2 in Keil. when the program reached the below lines this error appear: "Cannot access target Shutting down debug session." GPIOA->MODER = 0xFFFFFFFF; ...
  • Cannot access target
    Hello, I am using cortex M microcontroller, working with STM32F051 microcontroller on discovery kit. I am trying to do a project using ADC. I have assigned one pin as ADC using an industrial accelerometer...
  • Cannot access target, shutting down debug session
    Hi Im Bagus, I have trouble with debug session, i can't debug with simple blink code, Before im using simple blink code , i try dht11 with i2c lcd program but it was same with error "Cannot access...
  • cannot access memory and cannot entry debug mode
    i write a short program into my mcu then i cause keil cant not write program again always shows cannot access memory and cannot entry debug mode, it not cause by hardware i sure, two board with same...
  • ulink2 error: cannot access memory, cannot enter debug mode
    Hi! IÂ'm working on a project with the "Stellaris® Ethernet-enabled Intelligent Display Module with PoE RDK" (LM3S6918). - Please do not matter about my English. I know it is not very well and...