• in debug mode, won't enter main()
    Hello, I am looking for some help with my Keil uVision 5.27. I am able to run some example code for my chip that I downloaded from NXP. I have 0 errors and 0 warnings. I am able to go into the debug...
  • Program won't run to Main
    I'm running an LPC2144, and my program won't run to main - it freezes up in a 3-line loop in the disassembly window - a BMI instruction in my boot block at 0x7FFFD2DA loops back to 0x7FFFD2D6 and repeats...
  • Code runs only in debug mode
    Hi, I built a bootloader for a STM32F107vc. The bootloader was stored at address 0x08000000 to 0x08009800 and the main application was saved at 0x08009800. Off course, I changed the Vector Table...
  • Set "Use Simulator" and "Run to main()" in Debug but does not stop at main()
    I am using uVision V5.15.0 and built an generic M4 based project with "Hello World" program. Set "Use Simulator" and "Run to main()" in Debug tab, built code and started Debug Session, but debugger does...
  • While running keil in debug mode, it is stopping.
    I am using MCU Cortex-M4 and running keil on simulator. In debug mode while running it is getting stopped at _sys_open function in call stack but in text editor arrows showing at SystemInit after stopping...