• Device could not be powered up
    Good day to you all! Now I have another problem with the DEBUG I got this error "device could not be powered" and in the Build output message it is as follows: I use the ULINK2 debugger to program a...
  • debug error Device could not be powered up
    no flying leads, no shorts, no static - suddenly my device behaves this way is this something I could have done is there a cure, I build a new project for check - same error from manual...
  • Could not stop ARM device?
    I am using ULINK to debug the LPC2132 board. They work well for some days. But now a problem appeared. Everytime I want to download code to FLASH, always get"Could not stop ARM device, please check your...
  • "could not stop ARM device"
    uVision 3... I try to stop the debugger to see why my application is crashing. But then I get "Could not stop ARM device! Please check the JTAG cable." I then have to cycle power to be able to run my...
  • Could not stop ARM device !
    In an effort to write a boot loader, I have changed the configuration so that the device starts executing code from bank 1. It doesn't work. ... Since then I am unable to access the flash device. ...