• SWD connection
    Hello everyone! I'am in a design phase of my first PCB mounter with an ARM processor, and I'am not sure if i correctly connected the programmers pins to the mcu ports. My processor is: STM32F302RCT6...
  • connection to host lost
    i am trying to run some simple code written in C51 version 6.2v using MON51 and i am getting error connection to host is lost! i can not figure out the problem, my installation command for mon51...
  • Boot Code in a loop....
    I am using an LPC2214 and trying to run from the flash. The only way I can program the chip is through the Keil Ulink connector. I use the LPC2000 256k flash programming algorithm provided with...
  • Lost
    I just got the v4 of Keil. I am programming with a 8 bit 8051 micro controller. I was wondering if there are any good books or materials that will help me understand programing alot better. I look at...
  • Is ossible detect connected SWD debug probes on STM32F?
    Is possible in program detect connection Debug Probes on SWD, for examples J-Link or ULINK2? Why? If Debug Probes is connected stdout on SWOUT pin If Debug Probes is not connected stdout on USART1...