• ULINK2 1.8v chip, communicaiton failure
    Can you use a ULINK2 for SWD on a lpc1102lvuk. This chip is a 1.8v chip. i'v set the internal jumper of the ULINK2 to the ARM position, but i get a communication falure. also in the Target/Debug/Settings...
  • ULink2 and SWD
    Hello Folks, Is there any way to get the ULINK2 running with SWD? I see on the website a dialog showing how to switch between normal JTAG and SWD? When I go the settings dialog none of these settings...
  • ULINK with 1.8V micro
    I have an AT91SAM7SE-EK, and a new board of our own design. I can successfully program both boards using SAM-PROG. I also have a ULINK (not ULINK2). I can program my code onto the eval kit using...
  • ULINK2/VMware 'SWD Communication Failure'
    Hello I'm running a Windows 7(64-Bit) client on a VMware Windows 10(64-Bit, previously 8.1 and 7) host. The target driver setup shows the serial no. of the ULINK2, but there is a SWD Communication...
  • SWD communication issue
    I'm using LoRa development board from Acsip based on STM32L073RZ micocontroller (ARM Cortex M0+ family). SWD pins on this board is as following: 3.3V, SWD(/A13), SWC(/A14), GND. Initially swd connection...