• amplify voltage
    hi i m using 89c51 , the output voltage of port1 is approx 5 volt, but i need 12 voltage as my requirement, i used simple NPN transistor, but the output is approx same with base voltage, actually...
  • compare voltage
    Hi, my program: EP: MOV A,ADC0H CJNZ A,#175D,EP i have problem jumping to the next subrountine when i detect 1.75V from power supply it will start to display if not it will display...
  • MSC12x : Low Voltage Detection Interrupt Generation
    I'm trying to simulate a low voltage condition on MSC1211 (digital/analog) but have no success. Any sugestion ? Regards Viktor Gottschald
  • Low Voltage Operation of LPC3250
    Hi, I am using LPC3250 for my design. My system has to be very power efficient therefore I have to apply some power management techniques. When I checked the user manual I saw Low-Voltage Operation...
  • read voltage on pin mcb2300
    Dear All, I have a mcb2300 board with LPC2378. I want to read the voltage with Test Multimeter from PIN0.0. I read from Document that this pin corresponds to the PIN 66 on the board. So I set pin...