• hello
    Hello all, I am using the LCP2378 controller for my project.My project functionality is to measure the temprature using temp sensore. I use ULINK2 for downloading my code and debbuging same....
  • About hello example in KeilC
    The hello sample example in keil C can use printf to output message in serial port window#1. But, I had tried to modify my project to do the same job, it's failed. I had check option of target to be...
  • programming "Hello" example with MiniMon
    Hi, I am new to micro-controllers word. I am trying to burn the example code "Hello" to C167CR-LM device (it located in C:\Keil\C166\Examples\Hello). I entered the device to bootstrap mode, and connected...
  • run " hello" program
    Why I run the hello problem, the response is : wrong location : 400B:0142 ... Then fail to creat parameter file. Why ? Thanks
  • Hello Per
    Dear Per, Thanks For your Reply. If I have UART 1 code then I never raised this question. And really Your post is very touchy You should register on every forum and paste same answer on post...