• Failed to Autobaud - Step1
    hi friends, I am new learning for ARM programming truely for to say for programming also .so please tolerate me. i have NXP LPC 2148 development board with its correct hex file to blink leds (it...
  • problem in autobauding in lpc2148
    I was programming lpc2148 using max232, crystal 11.0592MHz at 2400 baudrate using flash magic,but when i loaded the below code the problem of "operation failed ,Can't Autobaud" comes in the picture...
  • XC16x Autobaud detection unit
    Hi, can somebody help me with the right setup for using the the autobaud detection unit the right way. I have problems with the generally steps to propperly setting up the ASC. Also a more detailed...
  • autobaud with Large Memory Model
    I have a MSC1200EVM. The following test program runs as expected on the board with a small memory model, but the terminal shows endless y umlauts when a Large Memory Model is used. Should autobaud()...
  • PK51 snding a 0xA5 instead of 0x55 for autobaud
    I am trying to use PK51 to program/flash P89LV51RC2 using ISP (In-System Programming). However, PK51 sends character 0xA5 instead of 0x55 ("U") during autobaud phase, which causes P89LV51RC2 to not enter...