• L293D Motor Runs at low Voltage
    Hi all, I need a small help regarding L293D. I am making a small project using L293D. Bo motor which hardly consumes 60ma at 5v. i am powering my L293D using a step up circuit 3.7V to 5V from 3.7v...
  • voltage low p1.4 p1.7 seehau emulator
    Hi I am having issues with voltage levels on pins p1.4-p1.7 on a seehau emulator with c51 pod. My target is NXP 8051 based CMOS microcontroller with 32 I/O Lines, 3 Timers/Counters, 6 Interrupts/4 Priority...
  • MSC12x : Low Voltage Detection Interrupt Generation
    I'm trying to simulate a low voltage condition on MSC1211 (digital/analog) but have no success. Any sugestion ? Regards Viktor Gottschald
  • voltage generation
    Dear all, i have written a code which is as follows //whenever the microcontroller receives a input ,it should generate a voltage pulse of 5v or more at the output port which will be used actuate the...
  • amplify voltage
    hi i m using 89c51 , the output voltage of port1 is approx 5 volt, but i need 12 voltage as my requirement, i used simple NPN transistor, but the output is approx same with base voltage, actually...