• STR9 Booting from flash bank1
    Hi I'm trying to get an application to run from flash bank 1 I have followed the instruction in the article http://www.keil.com/support/docs/3347.htm without success I have also tried the example...
  • Code space 128K
    Hello, I want to use the cygnal C8051F126 which have a code space of 128k. How should i configure the target in order to have access to it. Right now, i have the possibility in the code Rom size of...
  • ICP programing in LPC938
    how the ICP is used for programing LPC938. what is the procedure for this.
  • EPM900 ICP for LPC936 not working
    Hi, I'm using an EPM900 board with a LPC936FA as the bondout chip. So far I have been using it in Emulation mode - running my code through Uvision debugger - but now I want to load my code onto the...
  • Problem ICP Programming 89LPC901 using EMP900.
    I've followed the AN10258 appnote on ICP programing, where I've constructed a pin-to-pin adapter for the five required pins for ICP programming. Now at the bottom of Page6 of the appnote, there is a...