• USB to RS-232 using CDC on ATMEL 89C5131
    Hi all, I want to connect an atmel microcontroller to PC using USB. I use CDC driver to emulate the serial port and a small program in VB 6.0 to send and receive some data. The enumeration is fine,...
  • Usb not working
    In over qpqlpc2148 board p0.23 is open and not conected to vcc and gnd. So i make this pin high by setting p0.23 using IO0SET |=0x00800000. When connected to pc it shows same error msg that is One of...
  • USB Host working with NTFS
    Hi, I have Keil NCP LPC 1857 Eval Board and I'm trying to get the USB host working with NTFS. Is there some easy way to get the USB Host example code working using USB memory that is formatted to...
  • USB HUB not working
    Hi I am developing a project using nuvoton m263ki development board and using keil IDE The sample code of usb-host device connection check is not working properly When i connect usb hub, it gets...
  • What USB - serial converter works with uVision2?
    Greetings all, I have seen in various places suggestions that uVision will debug with a "high quality" USB - serial converter. What is a "high quality" USB - serial converter? How can a good one...