• MCB2300 Issue
    Hi all, i am facing one issue related to uart0 in keil MCB2300 board.i have loaded .hex file into LPC2388 in MCB2300 board.After loading,removed jumper int0 and rst(I am assuming these two are only...
  • SPI Clock issue of SPI with LPC2378
    Dear Sir, On Simulation a proper SPI clock is generated but in actual noisy clock is observed on CRO 1)Clock signal should be in square wave form? So if so for what reason noisy clock is seen on CRO...
  • Flash magic on MCB2300
    Flash Magic version is 4.11. Jumpers J10: ON Jumpers J13: OFF Jumpers J4: OFF any a operation of the follows gets the same error of "operation failed. failed to autobaud-step1" click "ISP...
  • MCB2300 interface with i2c serial EEPROM
    > I got trouble when I write and read PCF8582 EEPROM with MCB2300 board using I2C. > I have LPC2368 processor in MCB2300 board. > I use I2C1 interface for read and write EEPROM. > I got different...
  • SPI interface issue
    hai, i am developing a product in which i am interfacing NXP LPC2378 and jennic JN5139 through SPI. Here JN5139 is SPI master and LPC2378 is SPI slave. Only one master and one slave. Here master is...