• Use of LOAD command on KEIL to download
    Hi, Can anyone tell whether we can use LOAD command in KEIL IDE environment for downloading software? If so how to use this? Should the IDE be in debug mode to use this command? Regards Suds
  • How to load external AXF for debugging?
    I have axf file with debug info in DWARF2 format, built with ARM RVCT 2.2 build 503(built NOT under mVIsion ). I want to load this AXF file to uVision3 and then debug my axf with ARM simulator. I...
  • LOAD %L INCREMENTAL command in Ram.ini error
    Hi to all I am using an ini file to initialize the external ram to load code during debug at the end of the ram.ini file there is a command to load the code in ram LOAD .\Obj\FL0064.afx INCREMENTAL...
  • save - debug command
    Hi, what am I doing wrong? Always when I try this save c:\projekte\read.hex 0x80000000, 0x80010000 uVision is flooding my hard disk with waste data. Are there examples for the correct...
  • Could not load *.AXF for debugging
    Hi, I am working on a DK-LM3S9B96 board and everything works fine. When I switch to an internal development board, download to flash works fine but I can not switch into debug mode ! I only get this...