• Simulating a GPIO interrupt - FRDM-KL25Z
    I am trying to simulate a press-key interrupt for the FRDM-KL25Z board. Everything seems to be set up. For example, I can access all the registers in the simulation mode. The only problem is that...
  • Simulator Fails to Simulate GPIO
    Hi all, I programmed a simple blinky program for STM32f429. I tried it on the STM32F429-DISCOVERY development board and it worked just fine. However when I tried it in the simulator, every other...
  • MCB2300: GPIO Interrupt Problems
    Hi everyone, I'm new to programming with a MCB2300(LPC2378), and I'm having a little bit of trouble figuring out how to get the GPIO interrupts to work. I'm trying to detect a rising edge on...
  • GPIO Interrupts trigger problem
    I am using LPC1788 controller (FBD208pin package). I use some GPIO lines of Port 0 and 2 as external interrupts. There are Opto couplers, proxy sensors, etc sensors (that generate single pulse) are...
  • LPC2364 GPIO Interrupt Problem
    Hello all, I am trying to use a falling edge GPIO interrupt on P0.11. I setup the pin as an input and have tested it as such and it seems to work fine. PINSEL0 &= 0xFF3FFFFF; PINMODE0 &= 0xFFBFFFFF;...