• port in tristate mode
    Hi, I work on ST10F168 with 6M*16bits external ram. This external Ram is used by the microcontroller and a xilinx, so the datas and adress bus are divided by 2 chips. I would to know if i can put POL...
  • Programming external flash using ULink
    Is it possible to use the ULink to both program the XC16X Flash AND a flash chip attached to the XC16X. I get the impression it might be from the Option/debug setup but find the ULink rather under documented...
  • ULINK and XC161
    I'm not able to debug my XC161 (step-AB) board using ULINK ver1.1 (targhet not found). JTAG interface works with a lot of messages, but the debug session don't start. Is anybody out there actually using...
  • ULINK flashing Texas TMS
    Hi, i'm trying to flash the TMS470R1B1M Microcontroller with ULINK and the keil claims the following message : , i need to configure "Cannot Write to RAM for Flash Algorithms !". I've tried to change...
  • ULINK Flash Error
    Hello guys, When I download flash in Ram through ULINK Error comes LPC_IAP_256.flx " flash download fail " the same software when I download using UART works fine. What is worng ??? Is some file...