• Servo controlling program
    I've written this program for AT89S52 to control a servo.The signal pin of the servo is connected to the P1_0 of the chips and a LED is connected to the P2_7 of the chip.When I turned the circuit on...
  • Best way to control a servo?
    Hi, This might be a little OT but I've been exploring a few new ways of controling a servo. I'm using a 8051 board of my own design, a Hitec HS300BB servo and the control line of the servo is connected...
  • Controlling of Servo Motor Using LPC11C24
    I am having an FS90R Continous Servo Motor with 3 wires. 1.Vss 5V 2.PWM Signal 3. Gnd I have already initalized the PWM Signal through 16bit Timer Function from LPC11C24 Sample Program...
  • servo motor
    How can i enable PWM through this lines i'm using 8051C0F20 toolkit , should i be using 8 or 16 bit pwm i want to interface it with a servo motor 8-Bit Pulse Width Modulator Mode Each module...
  • Servo motor
    HI I AM REALLY STRANDED WITH THE SERVO MOTOR PROGRAM how do i programm a servo motor. i just want the motor to turn on after 5 sec then turn 90 degrees to the right and stay like that for 10 sec...