• cannot stop arm device
    when I want to program the AT91sam7s128 whit J-link faced with this massage:cannot stop arm device! why? so thx
  • uVision3+ ULINK cannot program devices
    Hello, I'm using uVision3 (V3.05b) and ULINK to develop programs for XC164CM. There is a problem with downloading programs. First of all, 'ULINK' could not be found in 'Options for Target ->...
  • Could not stop ARM device?
    I am using ULINK to debug the LPC2132 board. They work well for some days. But now a problem appeared. Everytime I want to download code to FLASH, always get"Could not stop ARM device, please check your...
  • Could not stop ARM devices
    "Could not stop ARM devices,please check JTAG cables" will frequently occues, if you use keil Vision IDE, the follows are some common reasons that cause the error. 1. JTAG cables issue 2. JTAG speed...
  • Could not stop ARM device !
    In an effort to write a boot loader, I have changed the configuration so that the device starts executing code from bank 1. It doesn't work. ... Since then I am unable to access the flash device. ...