• Programming for stepper motor
    Hello everyone., I am ruben I am in need of a Stepper motor control program to turn right and left and to rotate 180" each side. I am preferring at89s52 controller and using keil uvision3 kindly...
  • c167 stepper motor control
    Hi I am trying to interface a Stepper motor with a c167 microcontroller. I am using the motor to tilt and pan a camera. the motor can only move a maximum of 10 degrees per step. I would be grateful...
  • stepper motor
    i want to write a code to rotate a dish using 2 stepper motors. Motor 1: 0.126 degrees per day towards south Motor 2: 9.375 degrees towards west per hour can anyone help?
  • stepper motor
    hello all, i am interfacing stepper motor of 18.deg per step with lpc2148 . the motor has its own stepper driver card. i want to generate 1000 pulses in 1 revolution. time doesnt matter. i have equation...
  • stepper motor
    i want to increase stepper motor speed up to 1000 rpm, i am using atmega32 microcontroller so,it's Mimimum delay is 5ms.means 60 rpm,when i decrease the delay, stepper motor should be not work properly...