• Capacitive Touch Screen GT911
    hi i have a gt911 for 7 inch LCD, and have a ARM microcontoller as Host.do you have C code (example). with I2C, i send Configuration Bytes, but i see a continue pulse on INT pin, without any...
  • Problems with the Touch Interface and I2C
    Good afternoon, using here the STM32F429ZIT6 Discovery board and Keil uVision 5.14 I am developing a prototype for a DSP project with a GUI that makes use of the touch screen. The DSP part works...
  • Touch panel automatically sensing
    Hi I am developing a project with 7 inch touch screen display But the key is sensing automatically without touching Why is this issue I am reading touch screen by directly reading through 12 bit...
  • TOUCH SCREEN with 8051
    Hi all Is it possible to use a touch screen attached to a 8051/2 based board ? Elico
  • C167 - low byte write 'touches' high byte
    Hi, I'm a novice user, so apologies if this is a stupid question! I'm interfacing a video chip to the C167CR. To load the pallete table inside the chip a register (address 0x10) is written with...