• Monitor in Bootstrap mode
    I want to run the C166 monitor in bootstrap mode but have problems to get it running. <br> Since the memory map is quite exotic, finding proper monitor configuration might produce some headache. <br...
  • Monitor in Bootstrap mode
    I want to run the C166 monitor in bootstrap mode but have problems to get it running. Since the memory map is quite exotic, finding proper monitor configuration might produce some headache. But i do...
  • Monitor and Bootstrap mode
    I have a Question using the Keil Monitor (on a Phytec KC167 Board): When I start a debug session with my Phytec board, the monitor is being downloaded in bootstrap mode. But when I am debugging, my...
  • How to change the application start address?
    Hi, I'm using the STM32F103ZD uC and the Keil IDE uVision V4.03q. I would like to place my default application at the lowest flash address 0x0800 0000 and I like to place my bootloader at address...
  • Monitor & address windows
    I am using the Keil Monitor to debug my program on a ST10F269. Until recently I used the default monitor configuration for my hardware (Phycore 167HSE, 1MB ROM, 2X 512kB RAM), which is included by Keil...