Browse By Tags

  • MPS2+ Expansion ports possible frequency and usage

    We started working on a daughter card we want to connect via the expansion ports, and we trying to understand the 52 IOs of the two expansion ports frequency capabilities (Board aspect) , is there any information regarding it ?

    Are there any schematics…

  • Fail to compile the ARM MPS2 FPGA project

    Hi,

    I'm trying to build the MPS2 FPGA project (unmodified, as it is supplied in the kit) and constantly getting an error message saying "Quartus Prime Software quit unexpectedly".

    It always crashes at the "Partition Merge" stage after…

  • Fail to run the compiled MPS2+ project

    Hi,

    After compiling the MPS2+ FPGA designstart project (unmodified, as-is out of the box), i'm failing to run it on the FPGA.

    While the already downloaded image that arrives on the FPGA runs fine (i run the demo application), the image I compiled…

  • Program MPS2+ directly with Quartus programmer

    Is it possible to directly program the FPGA in the MPS2+ board with the Altera Quartus Programmer?

    As far as I understand is the MPS2+ 10 Pin FJTAG port not compatible to the Alter USB blaster.

    Is there another way to do this? 

  • What USB Blaster cable?

    Hello,

    I want to use an USB Blaster cable for rapid FPGA prototyping on the MPS2+. 

    The cables differ very much in price.  Is it recommended to buy an original Altera for over 200 Euro or can I use a cheaper nonamee one?

    Could you please recommend a cable…

  • Should I buy a ARM debugger for MSP2+ EVAL?

    Hello expert:

    In MSP2+ board, I found a micro USB connector and some ARM debugger connectors. Can I configure FPGA and run DS-5 using the same micro USB?

    Thanks

    Jimmy

  • Test Errors with DesignEval Kit

    I am currently in Evaluation phase of ARM Design Kits.

    I am using the exact steps present in arm_cortex_m3_designstart_eval_rtl_and_fpga_quick_start_guide to compile the RTL and run the tests.

    But, unfortunately after compiling the RTL I am getting a stack…

  • Test Errors with DesignEval Kit (arm_cortex_m3_designstart_eval_rtl)

    I am currently in Evaluation phase of ARM Design Kits.

    I am using the exact steps present in arm_cortex_m3_designstart_eval_rtl_and_fpga_quick_start_guide_100895_0000_00_en.pdf

    to compile the RTL and run the tests.

    But, unfortunately after compiling the…

  • BME280 on DesignStart Eval via SPI Shield0

    Hello,

    I'm trying to connect the DesignStart Eval System to the BME280 Environmental Sensor via SPI. I used the SPI Shield0 Pins (EXP[11 to 14]) to set the connection and activated alternate functions in uVision for these pins. But how can I set up the…

  • Prototyping of ARM Cortex-M Processor systems in FPGA

    If you are a microcontroller / SoC / ASIC designer working on Cortex-M processor based systems looking for an FPGA board for prototyping, I have a great news for you: ARM has released a new FPGA board called the Cortex-M Prototyping System.

    Key featu…