Wenkwei asked: "with the M3 designstart CMSDK, is it possible to design multi-master bus? In the IoT Cortex-M TRM, only an ahb-lite structure is illustrated. That document does mention AHB and APB expansion through INTEXP[1:0] but what if there are more…
Hi,
I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.
So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …
II refer to the example MCU system level in the document "arm_cortex_m0_designstart_eval_user_guide", put it into MPS2+ after synthesis, the software uses the following example in this directory.
D:\CMPS3\AT510-MN-80001-r2p0-00rel0\systems…
I use the ARM Cortex-M3 DesignStart Eval on the FPGA platform, I use J-link to download the program to the system but the system is not properly implemented. I downloaded the generated Hex file via J-link to the FPGA development board via Keil. Is the…
Hi.
TESTNAME=bootloader test sequence is in BP210 CM3 test sequence,
In especially, we could find the below code,
then we got the below error message when we ran the simulation.
23490 ns UART: CMSDK Boot Loader 27270 ns UART: - load flash 45710…
