Browse By Tags

  • Is it possible to interface a high frequency sensor-signal output from an analog ASIC chip (e.g. several Kilohertz) using Cortex-M?

    This question was raised in the ‘Want to maximise your product design? See how a custom ASIC can help?' webinar, view all the questions in the round-up blog post.

  • CM3 DesignStart Build warning messages with Quartus Prime 17.0.2

    Hi,

    I am using Quartus Prime Lite 17.0.2 for building Cortex-M3 DesignStart RTL.

    I can successfully build the RTL, but I got some critical warnings as follows. Can I ignore these warnings? Is there any effects on the design by these warnings?

    Critical…

  • Test Errors with DesignEval Kit (arm_cortex_m3_designstart_eval_rtl)

    I am currently in Evaluation phase of ARM Design Kits.

    I am using the exact steps present in arm_cortex_m3_designstart_eval_rtl_and_fpga_quick_start_guide_100895_0000_00_en.pdf

    to compile the RTL and run the tests.

    But, unfortunately after compiling the…

  • BME280 on DesignStart Eval via SPI Shield0

    Hello,

    I'm trying to connect the DesignStart Eval System to the BME280 Environmental Sensor via SPI. I used the SPI Shield0 Pins (EXP[11 to 14]) to set the connection and activated alternate functions in uVision for these pins. But how can I set up the…