In updating my development environment to the new VS Code extension/environment(coming from uVision), I'm experiencing some issues with the flashing utility.
It seems that erasing the chip (in this case a HyperFlash chip connected to an MIMXRT1052CVL5B), is no problem, but when the tool tries to write the firmware to flash, it's unable to do so. I verified the sectors are actually erased, so that all seems to be executed well.And with uVision I'm not experiencing the same problem with seemingly the same settings.uVision configuration:
VS Code configuration:
As far as I can see, both should perform the same flashing operations, however the VS Code debugger only erases the chip, and fails programming with the following output:
"
* Executing task: Flash Device
Stopping running target Cortex-M7 on connectionConnected to running target Cortex-M7
Execution stopped in Privileged Thread mode at 0x604024D2
0x604024D2 BHI {pc}-6 ; 0x604024cc
Mapping segment 0x60400000 ~ 0x606B90D8 (size 0x2B90D8)
Starting flash programming operation: Programming 2855128 bytes to 0x60400000
Flash Progress: 0% (Erasing)
Flash Progress: 40% (Erased 2883584 bytes)
Flash Progress: 40% (Erasing completed)
Flash Progress: 40% (Writing)
Flash Progress: 85% (Writing failed)
Flash Progress: 85% (Programming failed)
Disconnected from stopped target Cortex-M7
ERROR(?): Flash programming failed: Failed to program 200 bytes at 0x60402400: 1
Flash failed
* The terminal process terminated with exit code: 1.
*Note: Application data starts at 0x60400000, due to the bootloader using which resides on the same chip.
I've also tried to make a custom armdbg command, but I can't seem to get the correct combination of arguments, which reflect the uVision configuration:
.\armdbg --program-only --target="<TARGET>" --log-config=info --clock-speed=25MHz --connect-pre-reset=true --workspace-folder="<WORKSPACE>" --image="<AXF_IMAGE>" --probe="ULINKpro" --stop-on-connect=true --port-mode="SWD" --cmsis-pdsc="D:\CMSIS\NXP\MIMXRT1052_DFP\19.0.0\NXP.MIMXRT1052_DFP.pdsc" --cmsis-device-name="MIMXRT1052CVL5B" --flash-config="algorithm=D:\CMSIS\NXP\MIMXRT1052_DFP\19.0.0\devices\MIMXRT1052\arm\MIMXRT105x_HYPER_256KB_SEC.FLM,region_start=0x60000000,region_size=0x04000000,ram_start=0x20000000,ram_size=0x00008000,erase_method=SECTORS,verify=true"
If anyone could help me with this, it would be greatly appreciated.