This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LPC55S14 Assembly programming

Hello

I got an interest on LPC55S14 Microcontroller. I'm using keil uvision 5 IDE. I would like to try programming this chip using assembly language. Can I have a sample startup file and a simple main file just to begin with?

By the way, I'm already familiar with arm cortex m3/m4 instructions.

Thanks and best regards.

Top replies

Andreas Barth 8 months ago +1 suggested

As far as I can see, the default startup file shipped by NXP in their LPC55S14_DFP version 18 is still in assembler. So you can have a look there (_YOUR_PACK_ROOT_\NXP\LPC55S14_DFP\18.0.0\devices\LPC55S14...