This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

USB endpoint configuration (Control Transfer)

Dear readers,

I’m developing a USB interface with KEIL MDK Plus (V5.35) and the STM32CubeMX (V6.5) tool.

Is it possible to configure endpoint 0 to a message pipe resp. to a control transfer type ? The Run-Time Environment looks like:

In principle it should be possible to edit BMAttributes = 0 (=control) but I think this is not supported by the library ? At least it is not a standard in the CustomClass_0.h file:

The reason is the used WinUSB driver  which can't access the "WinUsb_ControlTransfer" function.

Thanks in advance!

Best regards