We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am attempting to enable a specific pin in the GIPOA. When I enter debug mode and execute the command that should enable the pin: ODR8, it does not enable. So, I tried to enable it manually using the check box in the System Viewer Window -> GPIO -> GPIOA + ODR. The check shows up for a split second then goes away. It will not allow me to change any of the check boxes.
Is there a simple solution to this?
Thank you.
I forgot to include, I am using uVision4.