We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello Keil community,
I have an Atmel AT91SAM7x256 board with selfmade assembly startup code. For testing I had connect a simple switch at PioB to enter the external Interrupt. In simulation mode I can enter the IRQ_Hanlder in single steps without problems . But in debugging Mode the Programm did only enter the IRQ when I start the programm with the "run" Button, but not with single steps. :-(
My questions is now how can I configure the Keil debugger to enable the Interrupt in single step mode? Or maybe there are any special registers in the Atmel processor where I can enable it?
Many thanks and best regards
Norman