• State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 22 subscribers
  • Views 1201 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADUC7026 JTAG

Saul Lopez

Hi,

I am attempting to communicate with the ADUC7026 via the JTAG connector so that I may program it. I am using the mIDAS-Link interface module for communication but to no avail. However, I
am able to communicate with the ADuC7026 Eval Board without a single problem.

When it fails to communicate, it states the following error:
Attempting to read 0x01, read 0x07. It also states that my configuration settings
might need adjusting.

Has anyone experienced this problem before? Can someone offer some insight into this
problem please.

Any help would be greatly appreciated.

Saul

Parents
  • 0 in reply to Andy Neil

    Hi Keil,

    I actually got it to work. What was causing it to not communicate was our
    ADM708 3V uProcessor supervisory circuit. It's driving pin 69 (BM) low.
    So it was not the ADUC7026 that was failing, it had to do with our
    external circuitry.

    In any case, thank you very much for your help.

    Regards,

    Saul

Reply
  • 0 in reply to Andy Neil

    Hi Keil,

    I actually got it to work. What was causing it to not communicate was our
    ADM708 3V uProcessor supervisory circuit. It's driving pin 69 (BM) low.
    So it was not the ADUC7026 that was failing, it had to do with our
    external circuitry.

    In any case, thank you very much for your help.

    Regards,

    Saul

Children
No data