This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Show code at address in disassembly window

Hi sir,

There are some problems in using AGDI.When I show code at some address in disambley window, uVision IDE have no response for a long time and somtimes it display at the incorrect address in disambley window. Can you give me some directions what cause this problem.

eelin

Parents

0 eelin tseng over 21 years ago in reply to Keil Software Support Intl.

Dear Sir,

I use the the example Keil\C51\Examples\Bank_EX1 in simulator. Even though I shows code at B01:0x8000,this situation will be happened. There are real code in here.Are you sure that you duplicate this by doing all of the step, especially step3? Because I found that is main reason.

eelin
Cancel
Vote up 0 Vote down

Cancel

Reply

0 eelin tseng over 21 years ago in reply to Keil Software Support Intl.

Dear Sir,

I use the the example Keil\C51\Examples\Bank_EX1 in simulator. Even though I shows code at B01:0x8000,this situation will be happened. There are real code in here.Are you sure that you duplicate this by doing all of the step, especially step3? Because I found that is main reason.

eelin
Cancel
Vote up 0 Vote down

Cancel

Children

0 Keil Software Support Intl. over 21 years ago in reply to eelin tseng

Still unable to duplicate your problem in the simulator. Please send screen pictures to support.intl@keil.com so that we get a better idea of the problem.
Cancel
Vote up 0 Vote down

Cancel