Hi Everybody, I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data. Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them? Thanks in advance. :) Kind Regards, Dennis Ebben
Yes, of course. I'm using (i.e. I'm trying to use) the IIC of a XC161CJ (in polling mode). Using the Pins of P9 with a software emulated I2C Bus would be an alternative, but I'd like to avoid this. Uwe
Hi Uwe, sorry for delay, I will mail it in some minutes. Good luck, Stefan