I have isd51.dll ver 2.34. I would like to use an ISD with TI TUSB3210 processor (like standard 8052 derivate). And I've got an Error message from ISD51 Monitor Error: 'There was no reply from the target system!' I correctly set baudrate to 9600, tested both in simulator and hyperterminal as well described in ISD51.htm file. The function with 'A'character and output character work perfectlly. So I go back to simulator and try send HEX 0xA5 by sin=0xA5 command in simulator - it display 0xF7 followed by 6 hex values. => It seems that all work OK. But when I try it in Hyperterminal it does'not work. So I think that when Debugger send initial command - no response from 8052 by UART. Where should be an error ? Radim
Hej i am doing some TUSB6250 but can't really get started, so if you would share some of the codes i like that.... Kasper