• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 4 replies
  • Subscribers 137 subscribers
  • Views 9187 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Checking bandwidth boundness on Mali-T720

JPJ

I'm trying to infer if our application is bandwidth-bound (I believe it's not the case) but I don't have the read/write beat counters suggested in Tutorial. Although, I believe the ones I have already "resolve" the beats to the actual bytes value ($MaliL2CacheExtReadsExternalReadBytes and $MaliL2CacheExtWritesExternalWriteBytes).

We seem to be using ~740MB/s of bandwidth but I'm not sure which number to benchmark this against. Presumably the 5GB/s mentioned in the above tutorial (which seems to apply to this GPU) but I was wondering if you could shed some light on this.

Parents
  • +1

    Hi JPJ, 

    For Midgard the capture will automatically covert beats into bytes, so you are correct that this has already been scaled. 

    A bandwidth of 740MB/s should be fine for a mobile system; in general GPU bandwidth measurements under 3GB/s should be fine even on an entry-level device. 

    The other thing you can check are the stall counters which the Midgard GPUs expose in addition to the bandwidth counters. Reviewing stalls as a percentage of GPU Active cycles is a good indicator of the memory system struggling. For normal content I'd expect to see stalls < 5% of the GPU Active cycles, although it is worth noting that stalls can happen for a number of reasons, not just high load (e.g. GPU clocked faster than the bus, so the GPU cannot use the bus every clock cycle).

    HTH, 
    Pete

Reply
  • +1

    Hi JPJ, 

    For Midgard the capture will automatically covert beats into bytes, so you are correct that this has already been scaled. 

    A bandwidth of 740MB/s should be fine for a mobile system; in general GPU bandwidth measurements under 3GB/s should be fine even on an entry-level device. 

    The other thing you can check are the stall counters which the Midgard GPUs expose in addition to the bandwidth counters. Reviewing stalls as a percentage of GPU Active cycles is a good indicator of the memory system struggling. For normal content I'd expect to see stalls < 5% of the GPU Active cycles, although it is worth noting that stalls can happen for a number of reasons, not just high load (e.g. GPU clocked faster than the bus, so the GPU cannot use the bus every clock cycle).

    HTH, 
    Pete

Children