This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Render passes in streamline.

Hi. I have a streamline Version 6.7.1, Build 20180716_103422. gator 6.71.

Can I somehow select render passes on streamline capture. I mean how to determine begin (if load attachment was happened) or end (if flushing memory from GPU to RAM was happened) of each render passes? Which counters should I have use?
Thank you.

Top replies

Peter Harris over 4 years ago +2 verified

Hi Aleksandr, Streamline isn't aware of any of the API behavior; it's purely based on sampling counters at a 1ms tick rate. Tile loads at the start of a pass will show up as texture access, but can...

Parents

0 Aleksandr over 4 years ago in reply to Peter Harris

Hi Peter.

Thank you for the answer.

I'm using Mali-G76 GPU.

Best reagrds,

Aleksandr.
Cancel
Up 0 Down

Cancel

Reply

0 Aleksandr over 4 years ago in reply to Peter Harris

Hi Peter.

Thank you for the answer.

I'm using Mali-G76 GPU.

Best reagrds,

Aleksandr.
Cancel
Up 0 Down

Cancel

Children

No data