Is there any extra parameter needed to start networking on FVP_MPS2_M7 simulator?

• Hi,

I need to publish a payload from mbed-os to MQTT broker. I am using FVP_MPS2_M7 as target, code is getting compiled but while running it on simulator(FVP_MPS2_Cortex-M7.exe) am getting an error code -3001 but when I use FVP_MPS2_M3 as target and simulator(FVP_MPS2_Cortex-M3.exe) it is publishing a payload to MQTT broker. 

I am using below command for M3 simulator :-

FVP_MPS2_Cortex-M3.exe -C fvp_mps2.smsc_91c111.enabled=1 -C fvp_mps2.hostbridge.userNetworking=1 -a "C:\Users\A704698\Desktop\ARM_Project\Mbed_Programs\Mqtt-Hello-World\BUILD\FVP_MPS2_M3\GCC_ARM\Mqtt-Hello-World.elf

For M7 simulator command is :-

FVP_MPS2_Cortex-M7.exe -C fvp_mps2.smsc_91c111.enabled=1 -C fvp_mps2.hostbridge.userNetworking=1 -a "C:\Users\A704698\Desktop\ARM_Project\Mbed_Programs\Mqtt-Hello-World\BUILD\FVP_MPS2_M7\GCC_ARM\Mqtt-Hello-World.elf

I have referred this link :- http://infocenter.arm.com/help/index.jsp?topic=/com.arm.doc.dui0370n/CJGDADEA.html

Do I need to set extra parameter for M7 simulator except hostbridge and smsc?

Your help will be appreciated.