Embedded and Microcontrollers forum GIC v3&4: Programming sequence of GIC Registers

State Accepted Answer
+1 person also asked this people also asked this
Replies 3 replies
Subscribers 142 subscribers
Views 7543 views
Users 0 members are here

Options

Related

How was your experience today?

GIC v3&4: Programming sequence of GIC Registers

Rakesh Reddy over 9 years ago

Hi.,

Is there any sequence in programming GIC Registers.

Physical Interrupts point of view, I have followed sequence as follows:
- GICD
- GICR
- GICC/ICC
Coming to Virtual Interrupts point of view, I had small doubt about which module to be programmed first either
- GICV/ICV (or) GICH/ICH

Can anyone help me on this.

This is as per my understanding. Please correct me if i am wrong.

Thanks,

Rakesh.

Top replies

Rakesh Reddy over 9 years ago in reply to Carmelo D'Agostino +1 verified

Thank you Carmelo for your kind response., I have downloaded and gone through that document. This document is helpful and is very clear, but it doesn't contain any information about Virtualization Concept...

Parents

+1 Rakesh Reddy over 9 years ago in reply to Carmelo D'Agostino

Thank you Carmelo for your kind response.,
I have downloaded and gone through that document. This document is helpful and is very clear, but it doesn't contain any information about Virtualization Concept (My 2nd question).
Can you please help me for the same.
Thanks,
Rakesh.
Cancel
Vote up +1 Vote down

Reply

Reject answer

Cancel

Reply

+1 Rakesh Reddy over 9 years ago in reply to Carmelo D'Agostino

Thank you Carmelo for your kind response.,
I have downloaded and gone through that document. This document is helpful and is very clear, but it doesn't contain any information about Virtualization Concept (My 2nd question).
Can you please help me for the same.
Thanks,
Rakesh.
Cancel
Vote up +1 Vote down

Reply

Reject answer

Cancel

Children

No data