This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

TZC400 configuration on ls1046ardb

Hi,
Can anyone help me with steps on how to configure TZASC on LS1046ArmV8 ? 

Thanks,
Faizan

Parents
  • I have enabled TZC400 for LS1046A and dividing DRAM0 ( start address:0x80000000) into 3 regions. Region 1 as  secure read only and other 2 regions as secure read write. But when I try to write to Region 1 which is secure read only It is allowing me to write . As far as i know region 1 should not allow me write .
    All my register values seems alright as expected
    Do you know anything about this..?

    Thanks for the response.

Reply
  • I have enabled TZC400 for LS1046A and dividing DRAM0 ( start address:0x80000000) into 3 regions. Region 1 as  secure read only and other 2 regions as secure read write. But when I try to write to Region 1 which is secure read only It is allowing me to write . As far as i know region 1 should not allow me write .
    All my register values seems alright as expected
    Do you know anything about this..?

    Thanks for the response.

Children
No data